If you decide to give your car a cool look, you can install it on the bottom of the neon lights, which will give your car a more sporty look bright. In order that would make a powerful and bright glow on the cars set special neon tubes that can provide a much more powerful glow in comparison to even the most powerful LEDs. Of course, such tubes are much more expensive than any light-emitting diodes, and install them is difficult because of severe embrittlement. In connection with these few craftsmen came up to install the LEDs in a special box perpendicular to the bottom of the car. Such housing mounted on the thresholds of the car and on the bumpers. Such lighting will be much cheaper than neon, and install it easier. What would make such a backlight to the bottom of your car you need to buy the right amount of light-emitting diodes, plastic pipe, plexiglass, preferably resistors with a resistance of 500 ohms, a good glue (come now), colorless silicone, as well as the line cord. All these materials you can easily buy at any hardware store. To set the backlight will not need a special tool is all you need can be found in any garage or workshop. Before you begin the installation you need to prepare all materials and tools. The first step is to make a body, which will be installed LEDs. You need to calculate the required number of tubes and place in which they will be installed. Typically, the number of tubes consists of 12 pieces. Three pieces on the bumpers and sills car. Cut a small tube of approximately 70-80 mm, then carefully cut them lengthwise. Received after the cut on the half-cylinder to make cuts at an angle, which is 30 degrees. After you do this by building a hair dryer to warm up half-cylinders and bend their edges, then all the excess neatly cut and trimmed, and then in the resulting shells are drilled holes, which will be installed LEDs and fixtures. Make a special reflector, this fits the usual foil which is glued to the rear housing. Prepare all your LEDs and resistors, for that would glow was bright LEDs can be polished surface, and cut down their butt. This revision will allow you to diffuse glow. After a complete revision and preparation of LEDs need to do to install it in pre-prepared case. Pike and Mount LEDs to the body rather long and tedious job that requires you to maximize the patience and perseverance, as well as accuracy. Establish housing need so that they would not be seen, a large space under the bumpers and sills of cars vases will make it without any special effort. Qualitatively made LED lighting will be almost no different from the more expensive neon. The main criterion in the manufacture of light with their hands will be your accuracy and tenacity that will make everything as best as possible and without haste. And for that to work was faster and more enjoyable you can call for help from friends who can help with installation and perhaps give some helpful tips for any installation or fastening LED light on your car. Stock up on essential tool and start upgrading your car.
